Access Vanish Soft Roll-Up Tonneau Cover for 2004-2014 Ford F-150, 2010-2014 F-150 Raptor & 2006-2008 Lincoln Mark LT (5'7" Bed, without Cargo Management System)
Free gifts included with your order
- Guaranteed FitmentTeam-confirmed fit or money back
- No Sales TaxZero sales tax on every order
- 30-Day Money-Back GuaranteeReturn it within 30 days of delivery for a refund
Questions or a custom quote?
Mon to Fri, 9am to 5pm EST
Complete your upgrade
Fits the same truck
See it on a truck
Features
- XT-Dial Tension, No Tools: Easy-grip dials on the front bar set how tight the vinyl sits. Turn both the same amount, counterclockwise to tighten, to keep it drum tight; Access says that makes the cover quieter, longer lasting and less likely to hold standing water.
- Element Seal Across the Front: A peel-and-stick Element Seal gasket comes in the box and runs along the top of the front bed wall, adding to the front and rear seals and the foam on both side rails. Like any soft cover it is weather-resistant, not waterproof; Access notes some moisture and dust can still get in.
- No-Drill Tight Bite Clamps: Six toothed clamps bite into grooves on the side rails and hold them inside the bed walls, with no drilling on most trucks. A few trucks bolt on or need a special sheet instead; the child page names it.
- Rides Just 1/2" Above the Bed: Access calls the Vanish its lowest-profile cover yet: it sits only 1/2" over the bed rails. Black aluminum bars and side rails carry silver bows, two on most beds and three on most long beds.
- Trigger Latch, Two Slide Locks: Drop the tailgate and one finger on the driver-side trigger frees the rear bar. Press the bar down to close and the latch catches on its own; a slide lock under the rear bar on each side pushes in to lock and pulls out to open.
- Hook-and-Loop Sides, Rolls Up: A 1" slide-in hook strip closes each side for the full length of the rail. Open it and one person can roll the cover up to the cab, where webbing straps with hooks hold the roll so you can use the whole bed.
Description & Fitment
The Access Vanish is a soft roll-up tonneau cover for the 2004-2014 Ford F-150, 2010-2014 F-150 Raptor and 2006-2008 Lincoln Mark LT with the 5'7" bed, without the Cargo Management System. It suits owners who want a low cover that rides just 1/2" above the bed and closes with hook-and-loop sides. No-drill Tight Bite clamps hold it on, and XT-Dial tension adjusts without tools. A trigger latch with two slide locks and an Element seal across the front set it apart.
Fitment & Compatibility
| Years | Model | Bed | Notes |
|---|---|---|---|
| 2004-2014 | F-150 | 5'7" | without Cargo Management System |
| 2010-2014 | F-150 Raptor | 5'7" | without Cargo Management System |
| Years | Model | Bed | Notes |
|---|---|---|---|
| 2006-2008 | Mark LT | 5'7" | without Cargo Management System |
Check your bed: Measure inside the bed floor from the bulkhead to the closed tailgate. This part is for the 5'7" box.
Not for: the 2015-2027 F-150 6'7" box (91379); the 2015-2027 F-150 5'7" box (91369).
About Access
Access roll-up covers come from Agri-Cover, Inc. of Jamestown, North Dakota, which says its covers are built there. Agri-Cover says it introduced the first roll-up tonneau cover, the Access Original, in 1991; it also makes LOMAX hard covers, truck racks and farm roll tarps.
Access calls the Vanish its lowest-profile truck bed cover yet, at 1/2" over the rails. It shares that height and the trigger latch with the entry-level TonnoSport, and adds XT-Dial adjusters, black side rails, a bulkhead gasket in the box and a 3-year warranty.
Authorized Access dealer. Agri-Cover sells Access covers through what it calls "Authorized Dealers all across the country" and "authorized online retailers." Your Access Vanish carries Agri-Cover's 3-year limited warranty.
Frequently Asked Questions
Will this fit my 2004-2014 Ford F-150, 2010-2014 F-150 Raptor & 2006-2008 Lincoln Mark LT?
Yes, if it has the 5'7" box (without Cargo Management System). Measure inside the bed floor from the bulkhead to the closed tailgate and match it to the label. If you're unsure, send us your VIN and we'll check.
Will it fit a truck with the Cargo Management System?
No. This part is for trucks without the Cargo Management System. If you're unsure, send us your VIN and we'll check.
How is the Vanish different from the TonnoSport?
Both sit 1/2" above the bed rails with a trigger latch, two slide locks, a 1" hook-and-loop strip and a flat rear bar. The Vanish steps up to XT-Dial adjusters, black side rails, an Element Seal gasket in the box and a 3-year warranty; the TonnoSport, which Access calls its entry-level roll-up, has EZ-Dial adjusters, silver rails, the gasket as an option and 2 years of cover.
Will it keep rain and snow out of the bed?
It is built to keep most of it out: seals at the front and rear, foam between the rails and the bed, hook-and-loop down both sides and an Element Seal gasket on the front wall. Access's own sheet says no cover stops all moisture and dust, so wrap cargo that must stay dry and seal any factory holes or stake pockets. Brush snow off before you roll it up.
Does the cover lock?
The trigger latch catches every time you close it, and slide locks under the rear bar on both sides add a second hold; pull them out before you open the cover. Access says that with a locking tailgate the bed becomes a secure unit. It is a deterrent rather than a safe, so don't leave valuables in an unattended truck.
Will it work with my bed liner?
Usually, yes. Access lists spray-in liners, bed mats and most under-the-rail drop-in liners as compatible. Its sheet says an under-the-rail drop-in needs a little trimming at the front corners and near the tailgate, while an over-the-rail drop-in needs a lot more. On a spray-in liner, smoothing the front wall helps the gasket stick.
Installation
- Two 1/2" wrenches
- Torque wrench with a 1/2" socket
- Tape measure
- Scissors
- Safety glasses
Here's the short version. Follow Access's install sheet (below) for your truck's exact clamp positions, plus any special sheet your truck needs.
- Clamp the side rails. Set each rail with its weather strip against the inside lip of the bed and its guide resting on top, pushed forward to the front wall with the strike at the tailgate end (long beds join the two rail sections first). Clamp it near the front, at the middle and by the tailgate with the teeth in the rail grooves and the rail level and flush, then torque every clamp to 20 ft-lb or the value on your truck's special sheet.
- Fit the bulkhead seal gasket. With the air and surface above 60°F, wipe the top of the front wall with the alcohol pad. Peel and stick the gasket from the front of one rail to the opposite corner, raised side along the inside edge of the bed, and cut it to length.
- Attach the tension adjusters. Set the pre-rolled cover on the tailgate with the front bar facing up. Thread the left (L) and right (R) adjusters onto the front bar with their bolts and flat washers, and leave both loose.
- Mount and center the cover. Set the cover at the front of the bed and roll the front bar onto the rails with the vinyl flap tucked under it and the alignment tabs against the front wall. Bolt each adjuster under its rail without turning the dial, center the front bar so the gap is equal at both rails, then tighten the bolts you left loose.
- Close and set the rail height. Unroll the cover, set the rear bar in the strikes and press it down. Close the tailgate slowly; it should sit snug under the rear bar, so raise or lower the rails at the rear to suit, then re-check each clamp's torque, working from the cab back.
- Set the tension and seal. Open and close the rear bar a few times: it should snap shut, with no sag in the vinyl between the bows. Roll the cover open to adjust, turn both adjusters the same amount (counterclockwise tightens) and seal both sides with the hook-and-loop.
Stuck on a step?
- Pre-rolled cover assembly with front bar, rear bar, support bows, storage straps, trigger latch and 2 slide locks
- Driver and passenger side rails (two-piece rails on long beds)
- 6 Tight Bite clamps
- Left and right tension adjusters with nuts and bolts
- Seal gasket
- Alcohol prep pad
Specifications
| Brand | Access (Agri-Cover, Inc.) |
|---|---|
| Part Number | ACC91269 |
| Cover Type | Soft roll-up |
| Cover Material | Textured vinyl, reinforced, commercial grade, UV protected |
| Color | Black |
| Cold Weather | Vinyl stays flexible to -40°F |
| Profile | 1/2" above the bed rails |
| Frame | Black aluminum bars and side rails; 2 silver bows (3 on most long beds) |
| Latch | Trigger latch, driver-side release, latches automatically on closing |
| Slide Locks | 2, under the rear bar (one per side) |
| Tension Control | XT-Dial tension adjusters, no tools |
| Sealing | Front and rear seals, side-rail foam, Element Seal bulkhead gasket |
| Side Closure | 1" slide-in hook and loop |
| Rear Bar | Flat rear bar |
| Storage Straps | Webbing straps with hooks |
| Mounting | 6 Tight Bite clamps, no drilling on most trucks |
| Built In | Jamestown, North Dakota, USA |
| Bed Length | 5'7" |
| UPC | 834532007646 |
More media
8 videosWarranty, shipping & returns
-
Warranty
Agri-Cover, which makes Access covers, gives the Vanish a 3-year limited warranty against defects in material and workmanship, under normal use on the truck model the cover was made for.- The 3 years run from the date you received the cover or its date of manufacture.
- Agri-Cover repairs or replaces defective parts, at its option. No labor or service allowance is included, and incidental or consequential damages are not covered.
- Not covered: ordinary wear and tear, or damage caused by an accident, abuse, misuse, neglect, an alteration or a faulty installation.
- To make a claim or get registration help, email support@prestigetruck.com with your order number and the serial number (it is on a decal under the rear bar by the tailgate); we handle the claim with Agri-Cover.
- If Agri-Cover needs the cover back for inspection, we arrange the return authorization (RA); you ship it freight prepaid, and Agri-Cover pays the freight to send it back.
-
Free shipping
Ships free to the lower 48 states, with no minimum order.- Order by 5 PM ET on a business day and it starts processing the same day.
- The rolled cover ships in a long box, by freight or oversized parcel carrier depending on its size.
- Most orders arrive within 1-5 business days.
- We email your tracking number as soon as it ships.
-
Inspect on delivery
This roll-up cover ships in a long box. Check it as soon as it arrives.- Look for crushed ends, punctures or tears in the carton.
- If something looks wrong, take photos of the box and the parts (and if a driver asks you to sign, note the damage on the receipt).
- Open the box and check the parts against the parts list before you install.
- Email support@prestigetruck.com right away with your order number, a short note and photos. We send a replacement or a full refund at no cost to you.
-
30-day returns
Return it within 30 days of delivery, unused, in the original packaging, with proof of purchase.- Email support@prestigetruck.com with your order number. We reply within 1-2 business days with instructions.
- Damaged, defective or wrong item: we send a prepaid label or arrange a pickup.
- Changed your mind: you pay return shipping. No restocking fee.
- Refunds go back to your original payment method within 7 business days of approval. See our returns policy.